Reference v4.1.0 Instruction Manual

224 Network OS Command Reference

53-1003115-01

diag post enable

Enables and disables the power-on self-test (POST).

Synopsis diag post [rbridge-id] enable

no diag post [rbridge-id] enable

Operands rbridge-id Specifies the RBridge ID on which POST is run.

enable Enables the power-on self-test on the specified switch.

Defaults POST is enabled.

Command Modes Global configuration mode

Description Use this command to enable or disable POST during bootup.

Usage Guidelines Following the diag post enable command, update the startup-config by copying the running-config

to the start-up config, which takes effect during reboot or a power cycle.

Enter no diag post [rbridge-id] enable to disable the POST for that RBridge.

Examples To enable the POST for a RBridge:

switch# config

Entering configuration mode terminal

switch(config)# diag post rbridge-id 1 enable

switch(config)# exit

switch# copy running-config startup-config

This operation will modify your startup configuration. Do you want to continue?

[y/n]: y

1970/01/01-09:09:49, [DCM-1101], 2086, M2, INFO, VDX8770-4, Copy running-config

to startup-config operation successful on this node.

To disable the POST for a RBridge:

switch(config)# no diag post rbridge-id 1 enable