Reference v4.1.0 Instruction Manual

Network OS Command Reference 227
53-1003115-01
diag setcycle
2
DEFAULT - KEYWORD : COMMENT
1 - number_of_runs : number of passes of verify (0=infinite)
2 - min_lb_mode : Limits -lb_mode of tests
0 - sof : Enable stop testing on first fail
VERIFY - label : Label for run start and stop messages
1 - tbr_passes : turboramtest number of passes
16 - plb_nframes : portloopbacktest number of frames default speed
0 - plb5_nframes : portloopbacktest (lb_mode 5) number of frames default
speed
0 - plb7_nframes : portloopbacktest (lb_mode 7) number of frames
0 - pled_action : portledtest action for glowing all led's
1 - pled_passes : portledtest number of passes
1 - prbs_p7 : LC Backplane test with pattern PRBS7+
0 - prbs_p23 : LC Backplane test with pattern PRBS23+
0 - prbs_p31 : LC Backplane test with pattern PRBS31+
0 - cprbs_p7 : SFM Backplane test with pattern PRBS7+
0 - cprbs_p23 : SFM Backplane test with pattern PRBS23+
0 - cprbs_p31 : SFM Backplane test with pattern PRBS31+
16 - cplb_nframes : portloopbacktest in Core Blade number of frames
0 - cplb7_nframes : portloopbacktest in Core Blades (lb_mode 7) number of
frames
In fixed-configuration switches:
switch# diag setcycle
Do you want use default values [Y/N]? : y
DEFAULT - KEYWORD : COMMENT
replacing 3 with default 1
1 - number_of_runs : number of passes of verify (0=infinite)
2 - min_lb_mode : Limits -lb_mode of tests
1 - tbr_passes : turboramtest number of passes
16 - plb_nframes : portloopbacktest number of frames default speed
Committing changes to configuration
See Also show diag setcycle