Reference v4.1.0 Instruction Manual

Network OS Command Reference 229
53-1003115-01
diag turboramtest
2
diag turboramtest
This test performs a series of low-level structural tests to determine the basic health of the PCI or
PCIe bus and the memories inside the switch ASIC.
Synopsis diag turboramtest [passcnt count] [slot slot_id}
Operands passcnt count Specifies the number of test repetitions. By default, the test runs once.
Valid values range from 1 through 10.
slot slot_id Specifies the slot ID. This is mandatory for slot-based systems only.
Defaults The pass count (passcnt) is 1.
Command Modes Privileged EXEC mode (with the chassis disabled in offline mode).
Description Use this command to run a memory test of the ASIC chips.
Usage Guidelines During abnormal termination, the system might be in unusable state. Perform reload to reboot the
chassis or switch to recover.
In slot-based systems, the blade under test undergoes a reset and/or a reinitialization sequence
as part of the cleanup process.
CAUTION
This is a disruptive command. You must disable the chassis and switch before running the test. In
addition, you must reload or fastboot the switch or chassis after the test has completed running.
Examples In slot-based switches:
switch# diag turboramtest slot S2
% Info: This test should be run to completion. Please do not abort while it is
executing.
Running turboramtest...
Initializing ASIC 0 for BIST
Initializing ASIC 1 for BIST
Initializing ASIC 2 for BIST
turboRamTest on ASIC 0 PASSED
turboRamTest on ASIC 1 PASSED
turboRamTest on ASIC 2 PASSED
turboRamTest on slot S2 PASSED
% Info: Resetting the blade. Please wait till it gets initialized...
completed.
In fixed-configuration switches:
switch# diag turboramtest
% Info: This test should be run to completion. Please do not abort while it is
executing.
Running turboramtest ..............
PASSED.
See Also None