Reference v4.1.0 Instruction Manual

244 Network OS Command Reference

53-1003115-01

dot1x timeout server-timeout

Sets the 802.1X authentication-sever response timeout.

Synopsis dot1x timeout server-timeout seconds

no dot1x timeout server-timeout

Operands seconds Specifies the number of seconds that a switch waits for the response from

the 802.1X authentication server. Valid values range from 1

through 65535.

Defaults 30 seconds

Command Modes Interface subtype configuration mode

Description Use this command to set the authentication sever response timeout for a specific interface.

Usage Guidelines Enter no dot1x timeout server-timeout to return to the default setting.

Examples To set 40 seconds as the switch-to-authentication server transmission time on a specific

10-gigabit Ethernet interface:

switch(config)# interface tengigabitethernet 178/0/9

switch(conf-if-te-178/0/9)# dot1x timeout server-timeout 40

To set the switch-to-authentication server transmission time to the default value on a specific

1-gigabit Ethernet interface:

switch(config)# interface gigabitethernet 170/4/2

switch(conf-if-gi-170/4/2)# no dot1x timeout server-timeout

See Also interface, dot1x timeout re-authperiod, dot1x timeout supp-timeout, dot1x timeout tx-period