Reference v4.1.0 Instruction Manual

Network OS Command Reference 261

53-1003115-01

error-disable-timeout interval

Sets the timeout for errors on an interface.

Synopsis error-disable-timeout interval seconds

no error-disable-timeout interval

Operands seconds Specifies the time for the interface to time out. Valid values range from 10

through 1000000 seconds.

Defaults 300 seconds

The timeout feature is disabled.

Command Modes Protocol Spanning Tree configuration mode

Description Use this command to set the interface to time out when an error occurs.

Usage Guidelines If xSTP is enabled over VCS, this command must be executed on all the RBridge nodes.

Enter no error-disable-timeout interval to return to the default setting.

Examples To set the timeout value to 10 seconds:

switch(conf-rstp)# error-disable-timeout interval 10