Reference v4.1.0 Instruction Manual

Network OS Command Reference 263
53-1003115-01
exceed-set-prec
2
exceed-set-prec
Optional command for configuring the CIR packet IP precedence of a class-map.
Synopsis exceed-set-prec prec-num
no exceed-set-prec prec-num
Operands prec-num Specifies that traffic with bandwidth requirements that exceed the rate
configured for CIR and sent to the EIR bucket will have packet IP
precedence set to the value in the prec-num variable. Valid values are 0
through 7.
Defaults None
Command Modes Policy-map class police configuration mode
Description This command configures the CIR packet IP precedence of a class-map.
Usage Guidelines Only the police cir and cbs commands are mandatory for configuring a class-map.
If the optional parameters for a class-map are not set, they are treated as disabled. To delete
parameters for a class-map, you must delete all policer parameters while in the policy-map class
configuration mode using the no police cir command.
This command is only supported on Brocade VDX 8770-4, VDX 8770-8, and later switches.
Use the no version of this command to remove the parameter from the class-map.
Examples Example of setting this parameter.
switch(config-policymap)# class default
switch (config-policymap-class)# police cir 40000
switch(config-policymap-class-police)# exceed-set-prec 4
See Also cbs,conform-set-dscp, conform-set-prec, conform-set-tc, ebs, eir, exceed-set-dscp, exceed-set-tc,
police cir, police-priority-map, policy-map, qos cos, service-policy, set-priority