Reference v4.1.0 Instruction Manual

Network OS Command Reference 267

53-1003115-01

fabric ecmp load-balance

Configures the hashing fields.

Synopsis fabric ecmp load-balance [dst-mac-vid | src-dst-ip | src-dst-ip-mac-vid | src-dst-ip-mac-vid-port |

src-dst-ip-port | src-dst-mac-vid | src-mac-vid]

Operands dst-mac-vid Configures the command to use destination MAC address and VID-based

load balancing.

src-dst-ip Configures the command to use source and destination IP address-based

load balancing.

src-dst-ip-mac-vid Configures the command to use source and destination IP and

MAC address and VID-based load balancing.

src-dst-ip-mac-vid-port

Configures the command to use source and destination IP, MAC address,

VID and TCP/UDP port-based load balancing.

src-dst-ip-port Configures the command to use source and destination IP and TCP/UDP

port-based load balancing.

src-dst-mac-vid Configures the command to use source and destination MAC address and

VID-based load balancing.

src-mac-vid Configures the command to use source MAC address and VID-based load

balancing.

Defaults None

Command Modes RBridge ID configuration mode

Description Use this command to configure the list of fields (in the incoming packets), used for hashing.

Usage Guidelines This command does not function in standalone mode.

Examples To set the ECMP load balance to use source and destination IP address-based load balancing:

switch(config)# rbridge-id 2

switch(config-rbridge-id-2)# fabric ecmp load-balance src-dst-ip

See Also fabric ecmp load-balance-hash-swap