Reference v4.1.0 Instruction Manual

Network OS Command Reference 313

53-1003115-01

ha disable

Disables the High Availability feature.

Synopsis ha disable

Operands None

Defaults HA is disabled.

Command Modes Privileged EXEC mode

Description Use this command to disable the High Availability (HA) feature on a switch. If the HA feature is

already disabled, this command has no effect.

Usage Guidelines This command is supported only on the active management module.

This command is not supported on the standby management module.

Do not use this command unless instructed by Brocade Technical Support.

NOTE

With the introduction of Network OS 4.0, failover is no longer disruptive for Layer 2.

Examples To display the syslog daemon IP addresses configured on a switch:

switch# ha disable

Service instances out of sync

1970/01/01-00:06:30, [HASM-1101], 111, MM1, WARNING, chassis, HA State out of

sync.

HA is disabled