Reference v4.1.0 Instruction Manual

320 Network OS Command Reference
53-1003115-01
hello (UDLD)
2
hello (UDLD)
Sets the hello transmit interval.
Synopsis hello hundred_milliseconds
no hello
Operands hundred_milliseconds Valid values range from 1 through 60 (in counts of 100
milliseconds).
Defaults 5 is the default value (500 milliseconds).
Command Modes Unidirectional link detection (UDLD) protocol configuration mode
Description Use this command to set the time interval between the transmission of hello UDLD PDUs from
UDLD-enabled ports.
Usage Guidelines Enter no hello to return to the default setting.
Examples To set the time interval to 2,000 milliseconds between hello UDLD PDU transmissions:
switch# configure
switch (config)# protocol udld
switch(config-udld)# hello 20
See Also protocol udld, multiplier (UDLD)