Reference v4.1.0 Instruction Manual

356 Network OS Command Reference

53-1003115-01

ip igmp last-member-query-interval

Sets the last member query interval.

Synopsis ip igmp last-member-query-interval milliseconds

no ip igmp last-member-query-interval

Operands milliseconds Response time in milliseconds. Valid values range from 100

through 25500 milliseconds.

Defaults 1000 milliseconds

Command Modes VE interface configuration mode

VLAN interface configuration mode

Router interface configuration mode

Description Use this command to set the last-member query interval on a specific interface. The last-member

query interval is the time in seconds that the IGMP router waits to receive a response to a

group-specific query message, including messages sent in response to a host-leave message.

Usage Guidelines Enter no ip igmp last-member-query-interval to remove the last-member query interval on a

specific interface.

Examples To set the last-member query interval to 1500 milliseconds on a specific VLAN interface:

switch(config)# interface vlan 100

switch(conf-Vlan-100)# ip igmp last-member-query-interval 1500

See Also interface, interface ve, ip igmp query-interval, ip igmp query-max-response-time,

ip igmp static-group