Reference v4.1.0 Instruction Manual

Network OS Command Reference 357
53-1003115-01
ip igmp query-interval
2
ip igmp query-interval
Sets the query interval.
Synopsis ip igmp query-interval seconds
no ip igmp query-interval
Operands seconds Response time in seconds. Valid values range from 1 through
18000 seconds.
Defaults 125 seconds
Command Modes VE interface configuration mode
VLAN interface configuration mode
Router interface configuration mode
Description Use this command to set the query interval. This is the amount of time between IGMP query
messages sent by the switch.
Usage Guidelines Enter no ip igmp query-interval to remove the query interval on a specific interface.
Examples To set the query interval to 500 seconds on a specific VLAN interface:
switch(config)# interface vlan 100
switch(conf-Vlan-100)# ip igmp query-interval 500
To remove the query interval from a specific VLAN interface:
switch(config)# interface vlan 100
switch(conf-Vlan-100)# no ip igmp query-interval
See Also interface, ip igmp last-member-query-interval, ip igmp query-max-response-time,
ip igmp static-group