Reference v4.1.0 Instruction Manual

362 Network OS Command Reference
53-1003115-01
ip igmp snooping mrouter
2
ip igmp snooping mrouter
Configures a VLAN port member to be a multicast router interface.
Synopsis ip igmp snooping mrouter {fortygigabitethernet rbridge-id/slot/port |
tengigabitethernet rbridge-id/slot/port | gigabitethernet rbridge-id/slot/port |
port-channel number}
no ip igmp snooping mrouter {fortygigabitethernet rbridge-id/slot/port |
tengigabitethernet rbridge-id/slot/port | gigabitethernet rbridge-id/slot/port |
port-channel number}
Operands interface Use this parameter to specify the interface.
fortygigabitethernet rbridge-id/slot/port
Specifies a valid 40-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
tengigabitethernet rbridge-id/slot/port
Specifies a valid 10-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
gigabitethernet rbridge-id/slot/port
Specifies a valid 1-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
port-channel number
Specifies the interface is a port-channel. Valid values range from 1
through 63 for standalone mode, and 1 through 6144 for Brocade
VCS Fabric mode.
Defaults None
Command Modes VLAN interface configuration mode
Description Use this command to configure a VLAN port member to be a multicast router interface, which is an
interface that faces toward a multicast router or other Internet Group Management Protocol
(IGMP) querier.
Usage Guidelines On the Brocade VDX family of switches, VLANs are treated as interfaces from a configuration point
of view. By default, all the DCB ports are assigned to VLAN 1 (VLAN ID equals 1). Valid VLAN IDs
are as follows: