Reference v4.1.0 Instruction Manual

386 Network OS Command Reference

53-1003115-01

ip ospf retransmit-interval

Configures retransmit interval.

Synopsis ip ospf retransmit-interval rtx-int

no ip ospf retransmit-interval

Operands rtx-int Retransmit interval in seconds. Valid values range from 0 through

3600 seconds.

Defaults 5 seconds.

Command Modes Interface subtype configuration mode

Description Use this command to set the time between Link-State Advertisement (LSA) retransmissions to

adjacent routers for this interface.

Usage Guidelines Enter no ip ospf retransmit-interval to reset the retransmit interval to its default.

Examples To set the retransmit interval to 10 for all OSPF routers on the OS-gigabit Ethernet interface

190/0/49:

switch(config)# interface tengigabitethernet 190/0/49

switch(conf-if-te-190/0/49)# ip ospf retransmit 10

To set the retransmit interval to 50 for all OSPF routers on the OSPF virtual Ethernet (VE)

interface 24:

switch(config)# rbridge-id 178

switch(config-rbridge-id-178)# interface ve 24

switch(config-ve-24)# ip ospf retransmit 50

See Also interface, interface ve, ip ospf area, ip ospf auth-change-wait-time, ip ospf authentication-key,

ip ospf cost, ip ospf database-filter, ip ospf dead-interval, ip ospf hello-interval,

ip ospf md5-authentication, ip ospf mtu-ignore, ip ospf network, ip ospf passive, ip ospf priority,

ip ospf transmit-delay