Reference v4.1.0 Instruction Manual

396 Network OS Command Reference

53-1003115-01

ip route next-hop-enable-default

Enables the default route for next-hop resolution.

Synopsis ip route next-hop-enable-default

no ip route next-hop-enable-default

Operands There are no operands for this command.

Defaults Disabled

Command Modes RBridge ID configuration mode

Description Use this command to enable a Brocade device to use the default route (0.0.0.0/0) to resolve a

next hop.

This command works independently from the ip route next-hop-recursion and

ip route next-hop ospf commands. If the default route is a protocol route, that protocol needs to be

enabled to resolve static routes using the ip route next-hop ospf command. If the default route

itself is a static route, you must configure the ip route next-hop-recursion command to resolve

other static routes by this default route.

Usage Guidelines Enter no ip route next-hop-enable-default to disable the default route for next-hop resolution.

Examples To enable the default route for next-hop resolution:

switch (config)# rbridge-id 30

switch (config-rbridge-id-30)# ip route next-hop-enable-default

See Also ip route next-hop-recursion, ip route next-hop ospf, ip route next-hop-vrf