Reference v4.1.0 Instruction Manual

Network OS Command Reference 397
53-1003115-01
ip route next-hop-recursion
2
ip route next-hop-recursion
Enables Brocade switches to use routes to resolve another route.
Synopsis ip route next-hop-recursion level
no ip route next-hop-recursion
Operands level Sets the number of levels of recursion allowed. Valid values range from 0
through 10. The default is 3.
Defaults Next-hop recursion level is 3.
Command Modes RBridge ID configuration mode
Description Use this command to enable next-hop recursive lookup by other routes, and set the next-hop
recursion level. If you want to disable the recursion configuration, set the value to 0. You can
re-enable the configuration later.
Usage Guidelines Enter no ip route next-hop-recursion to remove next-hop resolution configuration and revert to its
default.
Examples To set the next-hop recursion level to 7:
switch (config)# rbridge-id 30
switch (config-rbridge-id-30)# ip route next-hop-recursion 7
See Also ip route next-hop ospf, ip route next-hop-enable-default, ip route next-hop-vrf