Reference v4.1.0 Instruction Manual

Network OS Command Reference 413
53-1003115-01
lacp system-priority
2
lacp system-priority
Sets the Link Aggregation Control Protocol (LACP) system priority.
Synopsis lacp system-priority value
no lacp system-priority
Operands value Specifies the value of the LACP system priority. Valid values range from 1
through 65535.
Defaults The default value is 32768.
Command Modes Global configuration mode
Description Use this command to set the system priority of a local system. This determines which system is
responsible for resolving conflicts in the choice of aggregation groups.
Usage Guidelines Lower numerical values have higher priorities.
Enter no lacp system-priority to reset the system priority to the default value.
Examples To set the LACP system-priority to 68:
switch(config)# lacp system-priority 68
To clear the configured LACP system-priority:
switch(config)# no lacp system-priority
See Also None