Reference v4.1.0 Instruction Manual

426 Network OS Command Reference

53-1003115-01

lldp profile

Applies a Link Layer Discovery Protocol (LLDP) profile to an interface.

Synopsis lldp profile name

no lldp profile

Operands name Specifies the profile name. Valid profile name length is between 1 and

32 characters.

Defaults LLDP profile name.

Command Modes Interface subtype configuration mode

Description Use this command to apply a Link Layer Discovery Protocol (LLDP) profile to a specific interface.

Usage Guidelines You must use the profile command to create an LLDP profile before you can apply the profile to the

interface. Only one LLDP profile can exist at any time for a particular interface. When this

command is not present, the parameters defined in the global LLDP configuration are used.

Enter no lldp profile to delete the profile from the interface.

Examples To apply an LLDP profile called test on an specific 10-gigabit Ethernet interface:

switch(config)# interface tengigabitethernet 178/0/9

switch(conf-if-te-178/0/9)# lldp profile test

See Also interface, lldp dcbx-version, lldp disable, lldp iscsi-priority