Reference v4.1.0 Instruction Manual

430 Network OS Command Reference
53-1003115-01
logging raslog console
2
logging raslog console
Sets the severity levels for the RASLog console and allows users to temporarily stop showing
RASLog messages on the console.
Synopsis logging raslog console severity
no logging raslog console severity
logging raslog console stop [minutes]
logging raslog
console start
Operands
severity Specifies the minimum severity level of the message to pass through the
filter. Valid values consist of one of the following: INFO, WARNING, ERROR,
or CRITICAL. Input values are case-sensitive.
start Initiates RASLog messages.
stop Stops RASLog messages.
Defaults Severity level is INFO.
Command Modes Global configuration mode
Description Use this command to set the severity levels for the RASLog console.
Usage Guidelines This command is supported only on the local switch.
This command is not supported on the standby management module.
The total message storage available is 2048 messages.
When stopping or starting RASLog messages, the commands are not persistent and therefore are
not configuration commands.
If the command logging raslog console stop minutes is invoked before the previous time value
expires, the latest CLI duration applies.
Examples Standalone
To set the RASLog severity level:
switch(config)# logging raslog console WARNING
To reset the RASLog severity levels to the default value.
switch(config)# no logging raslog console
To stop RASLog messages for 1 minute:
switch# logging raslog console stop 1
Logging message have been blocked on console for 1 minutes
To start RASLog messages:
switch# logging raslog console start
2013/11/14-08:42:57, [RAS-3008], 5348, M2 | Active, INFO, VDX8770-4, Logging
messages to console has been reset by user.
See Also clear logging raslog, logging raslog console, show running-config logging