Reference v4.1.0 Instruction Manual

484 Network OS Command Reference
53-1003115-01
multiplier (LLDP)
2
multiplier (LLDP)
Sets the number of consecutive misses of hello messages before LLDP declares the neighbor as
dead.
Synopsis multiplier value
no multiplier
Operands value Specifies a multiplier value to use. Valid values range from 2 through 10.
Defaults Multiplier default value is 4.
Command Modes Protocol LLDP configuration mode
Description Use this command to set the number of consecutive misses of hello messages before LLDP
declares the neighbor as dead.
Usage Guidelines Enter no multiplier to return to the default setting.
Examples To set the number of consecutive misses:
switch(conf-lldp)# multiplier 2
See Also hello (LLDP)