Reference v4.1.0 Instruction Manual

Network OS Command Reference 497

53-1003115-01

neighbor ebgp-multihop (BGP)

Allows EBGP neighbors that are not on directly connected networks and sets an optional maximum

hop count.

Synopsis neighbor {ip-address | peer-group-name} ebgp-multiphop [max-hop-count]

no neighbor {ip-address | peer-group-name} ebgp-multiphop

Operands ip-address IPv4 address of the neighbor

peer-group-name Peer group name configured by the neighbor peer-group-name command.

max-hop-count Maximum hop count (optional). Range is from 1 through 255.

Defaults None

Command Modes BGP configuration mode

Description Use this command to allow EBGP neighbors that are not on directly connected networks and set

an optional maximum hop count

Usage Guidelines Use the no form of this command to disable this feature.

Examples

switch(config)# rbridge-id 10

switch(config-rbridge-id-10)# router bgp

switch(config-bgp-router)# neighbor 10.11.12.13 ebgp-multihop 20