Reference v4.1.0 Instruction Manual

542 Network OS Command Reference

53-1003115-01

port-channel path-cost

Sets the path-cost behavior.

Synopsis port-channel path-cost [custom | standard]

Operands custom Specifies to use the custom behavior, which sets the path-cost changes

according to the port-channel’s bandwidth.

standard Specifies to use the standard behavior, which sets that the path-cost does

not change according to port-channel’s bandwidth.

Defaults Path-cost is standard.

Command Modes Protocol Spanning Tree configuration mode

Description Use this command to set the path-cost behavior for the port-channel.

Usage Guidelines If xSTP is enabled over VCS, this command must be executed on all RBridges.

Examples To set the behavior for the path-cost to custom:

switch(conf-mstp)# port-channel path-cost custom

To set the behavior for the path-cost to standard:

switch(conf-mstp)# port-channel path-cost standard