Reference v4.1.0 Instruction Manual

562 Network OS Command Reference
53-1003115-01
profile
2
profile
Creates an LLDP profile.
Synopsis profile name
no profile name
Operands name Assigns a name to the profile. The name must be between 1 and 63 ASCII
characters in length.
Defaults None
Command Modes Protocol LLDP configuration mode
Description Use this command to create an LLDP profile.
Usage Guidelines When you apply an LLDP profile on an interface using the lldp profile command, it overrides the
global configuration. If a profile is not present, then the default global profile is used until you
create a valid profile. Up to 64 profiles can be created.
Enter no profile name to remove the named profile.
Examples To create a profile named test:
switch(conf-lldp)# profile test
To delete a profile named test:
switch(conf-lldp)# no profile test
See Also lldp profile