Reference v4.1.0 Instruction Manual

Network OS Command Reference 573
53-1003115-01
qos cos-mutation
2
qos cos-mutation
Applies a CoS-to-CoS mutation quality of Service (QoS) map on an interface.
Synopsis qos cos-mutation name
no qos cos-mutation
Operands name Specifies the name of the CoS mutation map.
Defaults No explicit CoS-to-CoS mutation QoS map is applied; the inbound CoS equals the outbound CoS.
Command Modes Interface subtype configuration mode
Description Use this command to apply a CoS-to-CoS mutation QoS map on a specific interface. Mutation
mapping is a method of modifying a QoS field in all packets on an interface. On ingress, mutation
mapping occurs before traffic classification and all other actions. On egress, mutation mapping
occurs after traffic classification and before all other actions.
Usage Guidelines The qos cos-mutation command is not available if the interface is in CEE Provisioning mode.
Enter no qos cos-mutation to remove the CoS-to-CoS mutation map.
Examples To activate a CoS-to-CoS mutation QoS map named test on a specific 40-gigabit Ethernet interface:
switch(config)# interface fortygigabitethernet 1/3/1
switch(conf-if-fo-1/3/1)# qos cos-mutation test
To remove a CoS-to-CoS mutation QoS map from a specific port-channel interface:
switch(config)# interface port-channel 22
switch(config-port-channel-22)# no qos cos-mutation
See Also interface, qos map cos-mutation, show qos maps