Reference v4.1.0 Instruction Manual

Network OS Command Reference 575

53-1003115-01

qos dscp-cos

Applies a defined DSCP-CoS map to an interface,

Synopsis qos dscp-cos name

no qos dscp-cos

Operands name Name of DSCP-to-COS mutation map

Defaults DSCP-to-CoS mutation is not enabled on interface.

Command Modes Interface subconfiguration mode (fo, gi, port-channel, te)

Description Use this command to apply a DSCP-to-COS mutation map defined by the qos map dscp-cos name

command to a specific interface.

Usage Guidelines Enter no qos dscp-cos while in the interface mode to remove the DSCP-CoS map from the

interface.

Examples To apply a configured QoS dscp-mutation map named test to a specific interface, enter the

qos dscp-cos name command while in the interface subconfiguration mode:

switch(config)# interface tengigabitethernet 16/2/2

switch(conf-if-te-16/2/2)# qos dscp-cos test

To remove a configured QoS dscp-mutation map named test from a specific interface, enter the

no qos dscp-cos command while in the interface subconfiguration mode:

switch(config)# interface tengigabitethernet 16/2/2

switch(conf-if-te-16/2/2)# no qos dscp-cos

See Also interface, qos dscp-mutation, qos map dscp-cos, show qos maps dscp-cos, qos dscp-cos,

show qos maps dscp-cos