Reference v4.1.0 Instruction Manual

576 Network OS Command Reference
53-1003115-01
qos dscp-mutation
2
qos dscp-mutation
Applies a defined DSCP mutation map to an interface,
Synopsis qos dscp-mutation name
no qos dscp-mutation
Operands name Name of DSCP mutation map
Defaults DSCP mutation map is not enabled on interface.
Command Modes Interface subtype configuration mode
Description Use this command to apply a DSCP-to-COS mutation map defined by the qos map
dscp-mutation name command to a specific interface.
Usage Guidelines Enter no qos dscp-mutation while in the interface mode to remove the DSCP mutation map from
the interface.
Examples To apply a configured QoS dscp-mutation map named test to a specific interface, enter the
qos dscp-mutation name command while in the interface mode:
switch(config)# interface tengigabitethernet 16/2/2
switch(conf-if-te-16/2/2)# qos dscp-mutation test
To remove a configured QoS dscp-mutation map named test from a specific interface, enter the
no qos dscp-mutation name command while in the interface mode:
switch(config)# interface tengigabitethernet 16/2/2
switch(conf-if-te-16/2/2)# no qos dscp-mutation
See Also interface, qos map dscp-mutation, show qos maps dscp-mutation