Reference v4.1.0 Instruction Manual

Network OS Command Reference 625

53-1003115-01

rib-route-limit (BGP)

Limits the maximum number of BGP Routing Information Base (RIB) routes that can be installed in

the Routing Table Manager (RTM).

Synopsis rib-route-limit num

no rib-route-limit num

Operands num Decimal value for maximum number of RIB routes to be installed in the

RTM. Range is from 1 through 65535.

Defaults This option is disabled. There is no limit.

Command Modes BGP Address-Family IPv4 Unicast configuration mode

Description Use this command to limit the maximum number of BGP RIB routes that can be installed in the

RTM.

Usage Guidelines Use the no form of this command to restore the default.

Examples To configure the device limit the maximum number of BGP RIB routes that can be installed in the

RTM:

switch(config)# rbridge-id 10

switch(config-rbridge-id-10)# router bgp

switch(config-bgp-router)# address-family ipv4 unicast

switch(config-bgp-ipv4u)# rib-route-limit 10000