Reference v4.1.0 Instruction Manual

Network OS Command Reference 653
53-1003115-01
service-policy
2
service-policy
Binds a policy-map to an interface.
Synopsis service-policy in | out policy-map name
no service-policy in | out
Operands in Binds policy-map to inbound traffic.
out Binds policy-map to outbound traffic.
policy-map name Name of the policy-map.
Defaults No service policy is created.
Command Modes Interface subtype configuration mode
Description Use this command to apply a policy-map containing a class-map with specific Policer parameters
and match critters to a switch interface. The policy-map must be configured before you can apply it
(refer to the description of the policy-map command).
Usage Guidelines Enter no service-policy in | out while in the applicable interface subconfiguration mode to remove
the service policy.
NOTE
This command is only supported on Brocade VDX 8770-4, VDX 8770-8, and later switches.
Examples To create a service-policy for outbound traffic on a specific 10-gigabit Ethernet interface:
switch(config)# interface tengigabitethernet 237/1/8
switch(conf-if-te-237/1/8)# service-policy out policymap1
To remove a service-policy for outbound traffic from a specific 10-gigabit Ethernet interface:
switch(config)# interface tengigabitethernet 237/1/8
switch(conf-if-te-237/1/8)# no service-policy out
To remove a service-policy for inbound traffic on a specific 10-gigabit Ethernet interface:
switch(config)# interface tengigabitethernet 237/1/8
switch(conf-if-te-237/1/8)# no service-policy in
See Also interface, class, qos cos, policy-map, show policymap