Reference v4.1.0 Instruction Manual

676 Network OS Command Reference
53-1003115-01
sflow enable (interface version)
2
sflow enable (interface version)
Enables sFlow on an interface.
Synopsis sflow enable
no sflow enable
Operands None
Defaults sFlow is disabled on all interfaces.
Command Modes Interface subtype configuration mode
Description Use this command to enable sFlow on a specific interface. sFlow is used for monitoring network
activity.
Usage Guidelines This command is supported on physical ports only.
On a Brocade VDX 8770 switch, SPAN and sFlow can be enabled at the same time.
On the Brocade VDX 6720 switch, SPAN and sFlow cannot be enabled at the same time.
Enter no sflow enable to disable sFlow on an interface.
Examples To enable sFlow on a specific 40-gigabit Ethernet interface:
switch(config)# interface fortygigabitethernet 1/3/1
switch(conf-if-fo-1/3/1)# sflow enable
See Also interface, sflow enable (global version), sflow polling-interval (interface version),
sflow sample-rate (interface version)