Reference v4.1.0 Instruction Manual

678 Network OS Command Reference
53-1003115-01
sflow polling-interval (interface version)
2
sflow polling-interval (interface version)
Configures the polling interval at the interface level.
Synopsis sflow polling-interval interval_value
no sflow polling-interval
Operands interval_value Specifies a value in seconds to set the polling interval. Valid values range
from 1 through 65535.
Defaults The defaut is 20.
Command Modes Interface subtype configuration mode
Description Use this command to configure the polling interval for an interface. The interval is the maximum
number of seconds between successive samples of counters to be sent to the collector.
Usage Guidelines Enter no sflow polling interval to return to the default value.
Examples To set the polling interval to 135 seconds on a specific 40-gigabit Ethernet interface:
switch(config)# interface fortygigabitethernet 1/3/1
switch(conf-if-fo-1/3/1)# sflow polling-interval 135
See Also interface, sflow polling-interval (global version), sflow enable (interface version),
sflow sample-rate (interface version)