Reference v4.1.0 Instruction Manual

682 Network OS Command Reference

53-1003115-01

sfp breakout

Displays the QSFP port breakout configurations.

Synopsis sfp breakout

no sfp breakout

Operands None

Defaults Breakout mode is set to disabled.

Command Modes Connector configuration mode

Description Use this command to display the QSFP port breakout configuration for the specified QSFP ports.

Usage Guidelines This command is an executable command and it could be executed under connector mode.

This command is destructible and irreversible. After this command, you must execute the “copy

running-config startup-config” command, and immediately perform a power-cycle on the

corresponding linecard/switch.

Use the no sfp breakout to disable breakout mode and create a single Fo interface.

Examples To enable SFP breakout on a connector:

switch(config)# hardware

switch(config-hardware)#connector 2/0/1

switch(config-connector-2/0/1)# sfp breakout

To disable SFP breakout on a connector:

switch(config-connector-2/0/1)# no sfp breakout

See Also show running-config hardware connector, connectorpower-off linecard, power-on linecard