Reference v4.1.0 Instruction Manual

Network OS Command Reference 713

53-1003115-01

show dadstatus

Displays the current DHCP auto-deployment (DAD) status output on the switch.

Synopsis show dadstatus

Operands None

Defaults None

Command Modes Privileged EXEC mode

Description Use this command to display the DAD status output on the switch.

Usage Guidelines If DAD fails, one of the following errors will show in the output:

1. DHCP auto-deployment failed during DHCP process

2. DHCP auto-deployment failed in sanity check

3. DHCP auto-deployment failed due to same firmware

4. DHCP auto-deployment failed to start firmware download

5. DHCP auto-deployment failed due to firmware download failure

Examples To display DAD status output on the switch:

sw0# show dadstatus

[1] : Thu Aug 15 23:22:50 GMT 2013

DHCP Auto-deployment enabled

[2] : Thu Aug 15 23:27:20 GMT 2013

DHCP Auto-deployment started firmwaredownload

[3] : Thu Aug 15 23:38:57 GMT 2013

DHCP Auto-deployment succeeded

sw0# show dadstatus

[1] : Fri Aug 16 12:02:44 GMT 2013

DHCP Auto-deployment enabled

[2] : Fri Aug 16 12:10:03 GMT 2013

DHCP Auto-deployment failed in sanity check.

See Also firmware download, firmware download logical-chassis, dhcp auto-deployment enable