Reference v4.1.0 Instruction Manual

852 Network OS Command Reference
53-1003115-01
show ip dhcp relay address interface
2
show ip dhcp relay address interface
Displays IP DHCP Relay addresses configured on a specific interface.
Synopsis show ip dhcp relay address interface [gigabitethernet rbridge-id/slot/port | tengigabitethernet
rbridge-id/slot/port | fortygigabitethernet rbridge-id/slot/port]
show ip dhcp relay address interface ve vlan_id {rbridge-id rbridge-id|all |range}
Operands gigabitethernet rbridge-id/slot/port A valid 1-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
tengigabitethernet rbridge-id/slot/port A valid 10-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
fortygigabitethernet rbridge-id/slot/port A valid 40-gigabit Ethernet interface.
rbridge-id Specifies the RBridge ID. This is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
ve VE interface.
vlan_id VLAN identification for interface.
rbridge-id rbridge-id Specific RBridge identification. You can specify multiple RBridge IDs,
separated by commas.
all All RBridge IDs in the logical chassis cluster.
range A range of RBridge IDs separated by a dashes or commas, for example:
1-3 - RBridge ID 1 through 3
1-3, 5 - RBridge ID 1 through 3 and RBridge ID 5
1, 3, 5, 6 - RBridge ID 1, 3, 5, and 6
Defaults If the rbridge-id keyword is omitted, IP DHCP Relay addresses display for the local switch.
Command Modes Privileged EXEC mode
Description Display IP DHCP Relay addresses configured on specific physical or virtual Ethernet (VE) interfaces
located on a local switch, specific switches, or all switches in a logical chassis cluster.
Usage Guidelines No spaces are allowed in the range string. The range does not need to be contiguous (for example,
1-2,5).
The gigabitethernet rbridge-id/slot/port parameter is used only on Brocade VDX 6710, Brocade
VDX 8770-4, and Brocade VDX 8770-8 switches. The prompt for configuring these ports is in the
following format:
switch(config-if-te-22/0/1)#