Reference v4.1.0 Instruction Manual

Network OS Command Reference 871
53-1003115-01
show ip ospf
2
show ip ospf
Displays the OSPF state.
Synopsis show ip ospf [vrf name [rbridge-id {rbridge-id | all}]]
Operands vrf name Specifies the name of the VRF instance. If this option is not used, details
for the default VRF are shown in the output.
rbridge-id rbridge-id Displays the information for the selected RBridge.
all Displays information for all RBridges.
Defaults None
Command Modes Privileged EXEC mode
Description Use this command to display the OSPF state.
Usage Guidelines When the RBridge ID is not specified, the output from the local node is displayed.
When the RBridge ID is specified, data from the corresponding specified RBridge is displayed.
When all is specified, data from all nodes in the cluster is displayed.
Examples
Switch# show ip ospf vrf testname
OSPF Version Version 2
Router Id 0.0.0.0
ASBR Status No
ABR Status No (0)
Redistribute Ext Routes from
Initial SPF schedule delay 0 (msecs)
Minimum hold time for SPFs 5000 (msecs)
Maximum hold time for SPFs 10000 (msecs)
External LSA Counter 0
External LSA Checksum Sum 0
Originate New LSA Counter 0
Rx New LSA Counter 0
External LSA Limit 14913080
Database Overflow Interval 0
Database Overflow State : NOT OVERFLOWED
RFC 1583 Compatibility : Enabled
NSSA Translator: Enabled
Nonstop Routing: Disabled
Originating router-LSAs with maximum metric
Condition: Always Current State: Active
Link Type: TRANSIT
Additional LSAs originated with maximum metric:
LSA Type Metric Value
AS-External 16711680
Type 3 Summary 16711680
Type 4 Summary 16711680
See Also None