Reference v4.1.0 Instruction Manual

886 Network OS Command Reference
53-1003115-01
show ip ospf traffic
2
show ip ospf traffic
Displays OSPF traffic details.
Synopsis show ip ospf traffic [{fortygigabitethernet rbridge-id/slot/port |
gigabitethernet rbridge-id/slot/port | loopback number | port-channel number |
tengigabitethernet rbridge-id/slot/port | ve vlan_id}] [[vrf vrfname [rbridge-id {rbridge-id | all}]] |
rbridge-id {rbridge-id | all}]
Operands fortygigabitethernet rbridge-id/slot/port
Displays traffic information for the specified, valid 40 Gbps port interface.
rbridge-id Specifies the RBridge ID. This parameter is not valid in standalone mode.
slot Specifies a valid slot number.
port Specifies a valid port number.
gigabitethernet rbridge-id/slot/port
Displays traffic information for the specified, valid 1-gigabit Ethernet
interface
rbridge-id Specifies the RBridge ID.
slot Specifies a valid slot number.
port Specifies a valid port number.
loopback number Specifies a loopback port number in the range from1 through 255.
port-channel number
Specifies the interface is a port-channel. The number of available channels
range from 1 through 63 for standalone mode, and from 1 through 6144
for Brocade VCS Fabric mode. However, the channel can be assigned any
number from 1 through 6144.
tengigabitethernet rbridge-id/slot/port
Displays traffic information for the specified, valid 10-gigabit Ethernet
interface.
rbridge-id Specifies the RBridge ID.
slot Specifies a valid slot number.
port Specifies a valid port number.
ve vlan_id Specifies a virtual Ethernet (VE) interface. Refer to the Usage Guidelines.
vrf vrfname Specifies the name of the VRF instance. If this option is not used, details
for the default VRF are shown in the output.
rbridge-id rbridge-id Displays the information for the physical, loopback, and SVI interfaces
specific to the selected RBridge.
all Displays the information for the physical, loopback, and SVI interfaces of all
nodes in cluster. There can be multiple loopbacks and SVIs with the same
RBridge ID from different nodes.
Defaults None
Command Modes Privileged EXEC mode