Reference v4.1.0 Instruction Manual

Network OS Command Reference 927
53-1003115-01
show mm
2
show mm
Displays information about the Management Modules present in the chassis.
Synopsis show mm
Operands None
Defaults None
Command Modes Privileged EXEC mode
Description Use this command to display information about the management modules present in a modular
switch. The output includes the following information:
Slot Displays the slot number. Slots for management modules are M1 and M2.
Type Displays the interface module type. The management module type is MM.
Description Module description
ID Displays the module ID. The ID for the management module is 112.
Status Displays the status of the module as one of the following:
VACANT The slot is empty.
POWERED-OFF The module is present in the slot but is powered off.
POWERING UP The module is present and powering on.
LOADING The module is present, powered on, and loading the initial configuration.
INITIALIZING The module is present, powered on, and initializing hardware components.
ENABLED The module is on and fully enabled.
DISABLED The module is powered on but disabled.
FAULTY The module is faulty because an error was detected.
UNKNOWN The module is inserted but its state cannot be determined.
Usage Guidelines Diagnostic tests (POST1, POST2) are not running on the management modules.
Examples To display the management modules present in a Brocade VDX 8770-4 chassis:
switch# show mm
Slot Type Description ID Status
----------------------------------------------------------------------
M1 MM Management Module 112 ENABLED
M2 VACANT
See Also show linecard, show sfm, show slots