Administrator's Guide v4.1.1 Manual

The Network OS CLI accepts abbreviations for commands. This example is the abbreviation for the
show qos interface all command.
switch# sh q i a
If the switch does not recognize a command after Enter is pressed, an error message displays.
switch# hookup
^
syntax error: unknown argument.
If an incomplete command is entered, an error message displays.
switch# show
^
syntax error: unknown argument.
Using Network OS CLI command output modifiers
You can filter the output of the Network OS CLI show commands by using the output modifiers
described below.
Network OS CLI command output modifiers TABLE 3
Output modifier Description
append Appends the output to a file.
redirect Redirects the command output to the specified file.
include Displays the command output that includes the specified expression.
exclude Displays the command output that excludes the specified expression.
begin Displays the command output that begins with the specified expression.
last Displays only the last few lines of the command output.
tee Redirects the command output to the specified file. Notice that this modifier also
displays the command output.
until string Ends the output when the output text matches the string.
count Counts the number of lines in the output.
linnum Enumerates the lines in the output.
more Paginates the output.
nomore Suppresses the pagination of the output.
FLASH Redirects the output to flash memory.
Using Network OS CLI command output modifiers
Network OS Administrator’s Guide 45
53-1003225-04