Administrator's Guide v4.1.1 Manual

Releasing a 40G QSFP port while in breakout mode
The following example shows you how to release a 40G QSFP port while in breakout mode.
switch(config-dpod-48/0/49)# dpod 48/0/49 release
Port should be Offline to change POD assignment.
switch(config-dpod-48/0/49)# exit
switch(config)# interface TenGigabitEthernet 48/0/49:1
switch(conf-if-te-48/0/49:1)# shut
switch(conf-if-te-48/0/49:1)# interface TenGigabitEthernet 48/0/49:2
switch(conf-if-te-48/0/49:2)# shut
switch(conf-if-te-48/0/49:2)# interface TenGigabitEthernet 48/0/49:3
switch(conf-if-te-48/0/49:3)# shut
switch(conf-if-te-48/0/49:3)# interface TenGigabitEthernet 48/0/49:4
switch(conf-if-te-48/0/49:4)# shut
switch(conf-if-te-48/0/49:4)# exit
switch(config)# dpod 48/0/49 release
switch(config-dpod-48/0/49)#
Releasing a 40G QSFP port while in breakout mode
548 Network OS Administrator’s Guide
53-1003225-04