Administrator's Guide v4.1.1 Manual

j) Enable PIM Sparse for this interface.
switch (config-ve-10)# ip pim-sparse
k) Exit Ve configuration mode.
switch (config-ve-10)# end
l) Repeat the configuration steps for each of the other VLANs shown in the example figure
for a deployment using a single VCS in Configuring PIM on page 579.
NOTE
For more information about PIM, refer to the Network OS Command Reference. Global
PIM CLIs are found in RBridge ID configuration mode, whereas the interface-level PIM
CLIs are found under their respective interface subconfiguration modes.
Configuring PIM
582 Network OS Administrator’s Guide
53-1003225-04