Administrator's Guide v4.1.1 Manual

Unsupported Network OS CLI commands in privileged EXEC mode (Continued)TABLE 108
Command name Command Description
show cee maps Displays CEE maps.
show cipherset Displays ciphers for LDAP and SSH.
show cli Displays CLI session parameters.
show clock Displays the date and time settings.
show diag Displays diagnostic information.
show dot1x Displays IEEE 802.1X Port-Based Access Control configuration data.
show edge-loop-detection globals Displays system-wide Edge-Loop-Detection status information.
show fcoe login Displays the FCoE CNA Login information.
show file Displays the contents of a file.
show history Displays command history.
show interface Displays interface status and configuration.
show ip Displays Internet Protocol (IP) information.
show lacp counter Displays Link Aggregation Control Protocol (LACP) counters.
show lldp Displays Link Layer Discovery Protocol (LLDP) configuration data
show monitor Displays interface status and configuration.
show netconf-state Displays NETCONF statistics.
show ntp Displays the active NTP server.
show parser dump Displays a parser dump.
show policy-map Displays the configured rate-limiting policy maps.
show port Displays port parameters.
show port-channel Displays the port-channel configuration.
show port-profile Displays the port profile configuration
show qos Display the Quality of Service (QoS) configuration.
show running-config Displays the running configuration.
show sflow Displays the sFlow configuration.
show spanning-tree Displays the Spanning Tree Protocol configuration.
TACACS+ Accounting Exceptions
Network OS Administrator’s Guide 727
53-1003225-04