Configuration Guide Manual

Brocade TurboIron 24X Series Configuration Guide 979
53-1003053-01
Sample 802.1X configurations
7 0 0 no no no
8 0 0 no no no
9 0 0 no no no
10 0 0 no no no
11 0 0 no no no
12 0 0 no no no
13 0 0 no no no
14 0 0 no no no
15 0 0 no no no
16 0 0 no no no
Syntax: show dot1x mac-session brief
The following table describes the information displayed by the show dot1x mac-session brief
command.
Sample 802.1X configurations
This section illustrates a sample point-to-point configuration and a sample hub configuration that
use 802.1X port security.
Point-to-point configuration
Figure 120 illustrates a sample 802.1X configuration with Clients connected to three ports on the
device. In a point-to-point configuration, only one 802.1X Client can be connected to each port.
FIGURE 120 Sample point-to-point 802.1X configuration
TABLE 152 Output from the show dot1x mac-session brief command
This field... Displays...
Port Information about the users connected to each port.
Number of users The number of users connected to the port.
Number of Authorized users The number of users connected to the port that have been successfully
authenticated.
Dynamic VLAN Whether the port is a member of a RADIUS-specified VLAN.
Dynamic Filters Whether RADIUS-specified IP ACLs or MAC address filters have been applied
to the port.