Configuration Guide Manual

204 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Configuring LLDP
• Whether the link is capable of being aggregated
• Whether the link is currently aggregated
• The primary trunk port
Devices advertise link aggregation information about standard link aggregation (LACP) as well as
static trunk configuration.
By default, link-aggregation information is automatically advertised when LLDP is enabled on a
global basis. To disable this advertisement, enter a command such as the following.
TurboIron(config)#no lldp advertise link-aggregation ports e 12
Syntax: [no] lldp advertise link-aggregation ports ethernet <port-list> | all
The link aggregation advertisement will appear similar to the following on the remote device, and in
the CLI display output on the device (show lldp local-info).
Link aggregation: not capable
MAC/PHY configuration status
The MAC/PHY configuration and status TLV includes the following information:
• Auto-negotiation capability and status
• Speed and duplex mode
• Flow control capabilities for auto-negotiation
• Port speed down-shift and maximum port speed advertisement
• If applicable, indicates if the above settings are the result of auto-negotiation during link
initiation or of a manual set override action
The advertisement reflects the effects of the following CLI commands:
• speed-duplex
• flow-control
• gig-default
• link-config
By default, the MAC/PHY configuration and status information are automatically advertised when
LLDP is enabled on a global basis. To disable this advertisement, enter a command such as the
following.
TurboIron(config)#no lldp advertise mac-phy-config-status ports e 4 to 12
The MAC/PHY configuration advertisement will appear similar to the following on the remote
device, and in the CLI display output on the device (show lldp local-info).
Syntax: [no] lldp advertise mac-phy-config-status ports ethernet <port-list> | all
+ 802.3 MAC/PHY : auto-negotiation enabled
Advertised capabilities: 10baseT-HD, 10baseT-FD, 100baseTX-HD,
100baseTX-FD,
fdxSPause, fdxBPause, 1000baseT-HD, 1000baseT-FD
Operational MAU type: 100BaseTX-FD