Configuration Guide Manual
Brocade TurboIron 24X Series Configuration Guide 493
53-1003053-01
Displaying IP configuration information and statistics
• IP forwarding cache – refer to “Displaying the forwarding cache” on page 500.
• IP route table – refer to “Displaying the IP route table” on page 501.
• IP traffic statistics – refer to “Displaying IP traffic statistics” on page 503.
The sections below describe how to display this information.
In addition to the information described below, you can display the following IP information. This
information is described in other parts of this guide:
• RIP
• OSPF
• BGP4
• PIM
• VRRP or VRRP-E
Displaying global IP configuration information
To display IP configuration information, enter the following command at any CLI level.
Syntax: show ip
NOTE
This command has additional options, which are explained in other sections in this guide, including
the sections below this one.
This display shows the following information.
TABLE 75 CLI Display of global IP configuration information – Layer 3 Switch
This field... Displays...
Global settings
ttl The Time-To-Live (TTL) for IP packets. The TTL specifies the maximum number of router hops
a packet can travel before reaching the router. If the packet TTL value is higher than the
value specified in this field, the router drops the packet.
To change the maximum TTL, refer to “Changing the TTL threshold” on page 462.
arp-age The ARP aging period. This parameter specifies how many minutes an inactive ARP entry
remains in the ARP cache before the router ages out the entry.
To change the ARP aging period, refer to “Changing the ARP aging period” on page 460.
TurboIron#show ip
Global Settings
ttl: 64, arp-age: 10, bootp-relay-max-hops: 4
router-id : 10.95.11.128
enabled : UDP-Broadcast-Forwarding IRDP Proxy-ARP RARP OSPF
disabled: BGP4 Load-Sharing RIP FSRP VRRP
Static Routes
Index IP Address Subnet Mask Next Hop Router Metric Distance
1 0.0.0.0 0.0.0.0 10.157.23.2 1 1
Policies
Index Action Source Destination Protocol Port Operator
1 deny 10.157.22.34 10.157.22.26 tcp http =
64 permit any any