Configuration Guide Manual

Brocade TurboIron 24X Series Configuration Guide 25

53-1003053-01

Configuring basic system parameters

TurboIron(config)#snmp-server enable traps holddown-time 30

The command in this example changes the holddown time for SNMP traps to 30 seconds. The

device waits 30 seconds to allow convergence in STP and OSPF before sending traps to the SNMP

trap receiver.

Syntax: [no] snmp-server enable traps holddown-time <secs>

The <secs> parameter specifies the number of seconds and can be from 1 – 600 (ten minutes).

The default is 60 seconds.

Disabling SNMP traps

TurboIron X Series devices come with SNMP trap generation enabled by default for all traps. You

can selectively disable one or more of the following traps.

NOTE

By default, all SNMP traps are enabled at system startup.

Layer 2 traps

The following traps are generated on devices running Layer 2 software:

• SNMP authentication keys

• Power supply failure

• Fan failure

• Cold start

• Link up

• Link down

• Bridge new root

• Bridge topology change

• Locked address violation

Layer 3 traps

The following traps are generated on devices running Layer 3 software:

• SNMP authentication key