Configuration Guide Manual

Brocade TurboIron 24X Series Configuration Guide 653
53-1003053-01
Displaying OSPF information
Displaying OSPF route information
To display OSPF route information for the router, enter the following command at any CLI level.
Syntax: show ip ospf routes [<ip-addr>]
The <ip-addr> parameter specifies a destination IP address. If you use this parameter, only the
route entries for that destination are shown.
This display shows the following information.
Events OSPF Interface Event:
Interface_Up = 0x00
Wait_Timer = 0x01
Backup_Seen = 0x02
Neighbor_Change = 0x03
Loop_Indication = 0x04
Unloop_Indication = 0x05
Interface_Down = 0x06
Interface_Passive = 0x07
Adjacent Neighbor Count The number of adjacent neighbor routers.
Neighbor: The neighbor router ID.
TABLE 101 CLI Display of OSPF route information
This field... Displays...
Index The row number of the entry in the router OSPF route table.
Destination The IP address of the route's destination.
Mask The network mask for the route.
Path_Cost The cost of this route path. (A route can have multiple paths. Each path represents a
different exit port for the Layer 3 Switch.)
Type2_Cost The type 2 cost of this path.
TABLE 100 Output of the show ip ospf interface command (Continued)
This field Displays
TurboIron#show ip ospf routes
Index Destination Mask Path_Cost Type2_Cost Path_Type
1 10.212.95.7 255.255.255.0 1 0 Intra
Adv_Router Link_State Dest_Type State Tag Flags
10.173.35.1 10.212.95.7 Network Valid 00000000 7000
Paths Out_Port Next_Hop Type Arp_Index State
1 6 10.95.7.250 OSPF 8 84 00
Index Destination Mask Path_Cost Type2_Cost Path_Type
2 10.3.63.0 255.255.255.0 11 0 Inter
Adv_Router Link_State Dest_Type State Tag Flags
10.95.7.250 10.3.63.0 Network Valid 00000000 0000
Paths Out_Port Next_Hop Type Arp_Index State
1 6 10.95.7.250 OSPF 8 84 00