Configuration Guide Manual

Brocade TurboIron 24X Series Configuration Guide 729
53-1003053-01
Generating traps for BGP
The parameters are the same as those for the show ip bgp flap-statistics command (except the
longer-prefixes option is not supported). Refer to “Displaying route flap dampening statistics” on
page 727.
NOTE
The clear ip bgp damping command not only clears statistics but also un-suppresses the routes.
Refer to “Displaying route flap dampening statistics” on page 727.
Generating traps for BGP
You can enable and disable SNMP traps for BGP. BGP traps are enabled by default.
To enable BGP traps after they have been disabled, enter the following command.
TurboIron(config)#snmp-server enable traps bgp
Syntax: [no] snmp-server enable traps bgp
Use the no form of the command to disable BGP traps.
Displaying BGP4 information
You can display the following configuration information and statistics for the BGP4 protocol on the
router:
• Summary BGP4 configuration information for the router
• Active BGP4 configuration information (the BGP4 information in the running-config)
• CPU utilization statistics
• Neighbor information
• Peer-group information
• Information about the paths from which BGP4 selects routes
• Summary BGP4 route information
• The router BGP4 route table
• Route flap dampening statistics
• Active route maps (the route map configuration information in the running-config)
Displaying summary BGP4 information
You can display the local AS number, the maximum number of routes and neighbors supported,
and some BGP4 statistics.
To view summary BGP4 information for the router, enter the following command at any CLI prompt.