Configuration Guide Manual

64 Brocade TurboIron 24X Series Configuration Guide
53-1003053-01
Securing access methods
Telnet access Not secured Regulate Telnet access using ACLs page 65
Allow Telnet access only from specific IP
addresses
page 68
Restrict Telnet access based on a client MAC
address
page 69
Allow Telnet access only from specific MAC
addresses
page 70
Specify the maximum number of login attempts
for Telnet access
page 70
Disable Telnet access page 73
Establish a password for Telnet access page 74
Establish passwords for privilege levels of the
CLI
page 74
Set up local user accounts page 78
Configure TACACS/TACACS+ security page 84
Configure RADIUS security page 100
Secure Shell (SSH) access Not configured Configure SSH page 945
Regulate SSH access using ACLs page 66
Allow SSH access only from specific IP
addresses
page 68
Allow SSH access only from specific MAC
addresses
page 69
Establish passwords for privilege levels of the
CLI
page 74
Set up local user accounts page 78
Configure TACACS/TACACS+ security page 84
Configure RADIUS security page 100
SNMP (Brocade Network
Advisor) access
SNMP read or
read-write
community strings
and the password
to the Super User
privilege level
NOTE: SNMP read
or
read-write
community
strings are
always
required
for SNMP
access to
the device.
Regulate SNMP access using ACLs page 66
Allow SNMP access only from specific IP
addresses
page 68
Disable SNMP access page 73
Allow SNMP access only to clients connected to
a specific VLAN
page 71
Establish passwords to management levels of
the CLI
page 74
Set up local user accounts page 78
Establish SNMP read or read-write community
strings
page 84
TABLE 18 Ways to secure management access to devices (Continued)
Access method How the access
method is secured
by default
Ways to secure the access method See page