Hardware Installation Guide User Manual

46 Brocade TurboIron 24X Series Hardware Installation Guide
53-1002981-01
Replacing the fan tray
5
CAUTION
Never leave tools inside the device.
Removing the fan tray
Use the following procedures to remove the fan tray from TurboIron 24X devices.
Figure 22 shows the location of the fan tray.
FIGURE 22 TurboIron 24X fan tray location
1. Disconnect the power cord from the power supply.
2. Loosen the two captive screws on the front plate of the fan tray and slide the tray out of the
device as shown in Figure 23.
FIGURE 23 Removing the fan tray
3. Insert the replacement fan tray, as shown in Figure 24, and push it all the way into the slot to
connect the interface.
NOTE
Ensure that the fan tray fits between the locating slides in the device.
4. Tighten the two captive screws to secure the tray in place.
1Fan Tray
1