User Manual

Unified IP MIB Reference 181
53-1003106-01
System CPU utilization table
6
Name, OID, and syntax Access Description
snAgentCpuUtilTable
brcdIp.1.1.2.11.1
None The table to list utilization for all CPUs.
snAgentCpuUtilSlotNu
m
brcdIp.1.1.2.11.1.1.1
Syntax: Integer32
Read-only The slot number of the module that contains the CPU.
snAgentCpuUtilCpuId
brcdIp.1.1.2.11.1.1.2
Syntax: Integer32
Read-only The ID of the CPU:
• For non-VM1/WSM management module, there is one CPU.
• For VM1/WSM, there is one management CPU and three slave
CPUs. The management CPU could be turned off.
• For POS and ATM, there is no management CPU but two slave
CPUs.
• The ID for the management CPU is 1. A value of 2 and greater
identifies the slave CPUs.
snAgentCpuUtilInterval
brcdIp.1.1.2.11.1.1.3
Syntax: Integer32
Read-only The value, in seconds, for this utilization. For both management and
slave CPUs, utilizations for 1 sec, 5 sec, 60 sec, and 300 sec intervals
are displayed.
snAgentCpuUtilValue
brcdIp.1.1.2.11.1.1.4
Syntax: Gauge32
NOTE: This object is
supported on
the Brocade
NetIron XMR,
Brocade NetIron
MLX, FastIron
GS, and
FastIron SX
devices. This
object is not
supported on
the Brocade
MLXe device.
Use the
snAgentCpuUtil
Percent and
snAgentCpuUtil
100thPercent
objects instead.
Read-only The statistical CPU utilization in units of one-hundredth of a percent.