User Manual

198 Unified IP MIB Reference
53-1003106-01
Switch port information
8
snSwIfInfoPortQos
brcdIp.1.1.3.3.5.1.12
Syntax: Integer
Read-write Indicates the Quality of Service (QoS) level selected for the port:
• low(0) – Low priority
• high(1) – High priority
• level0(0)
• level1(1)
• level2(2)
• level3(3)
• level4(4)
• level5(5)
• level6(6)
• level7(7)
snSwIfInfoPhysAddress
brcdIp.1.1.3.3.5.1.13
Syntax: Physical address
Read-only Shows the physical address of the port.
snSwIfLockAddressCount
brcdIp.1.1.3.3.5.1.14
Syntax: Integer
Read-write Indicates the number of source MAC addresses that are allowed on the
interface.
Valid values: 0 – 2048. The value 0 means an unlimited number of
addresses are allowed.
Default: 8
snSwIfStpPortEnable
brcdIp.1.1.3.3.5.1.15
Syntax: Integer
Read-write Indicates if STP is enabled for the port:
• disabled(0)
• enabled(1)
snSwIfDhcpGateListId
brcdIp.1.1.3.3.5.1.16
Syntax: Integer
Read-write Specifies the ID for a DHCP gateway list entry relative to this switch port.
Valid values: 0 – 32. A value of 0 means that the ID is unassigned.
snSwIfName
brcdIp.1.1.3.3.5.1.17
Syntax: Display string
Read-write Indicates the port name or description. This description may have been
entered using the CLI.
Valid values: Up to 32 characters for most devices. Up to 255 characters
for Brocade MLXe devices and other Brocade NetIron devices.
snSwIfDescr
brcdIp.1.1.3.3.5.1.18
Syntax: Display string
Read-only A textual string containing the slot or port information about the
interface.
snSwIfInfoAutoNegotiate
brcdIp.1.1.3.3.5.1.19
Syntax: Integer
Read-write Applies only to Gigabit Ethernet ports.
Indicates if auto-negotiation mode is enabled on the port:
• disabled(0) – The port will be placed in non-negotiation mode.
• enabled(1) – The port will start auto-negotiation indefinitely until it
succeeds.
• negFullAuto(2) – The port will start with auto-negotiation. If the
negotiation fails, then it will automatically switch to non-negotiation
mode. This option is not supported in stackable products with
Gigabit Ethernet ports.
• global(3) – The port negotiation mode follows the value of
snSwGlobalAutoNegotiate.
• other(4) – Non-Gigabit Ethernet port returns this value.
Default: global(3)
snSwIfInfoFlowControl
brcdIp.1.1.3.3.5.1.20
Syntax: Integer
Read-write Indicates if port flow control is enabled:
• disable(0)
• enable(1)
Default: enabled(1)
Name, OID, and syntax Access Description