User Manual

218 Unified IP MIB Reference
53-1003106-01
Loopback interface configuration table
9
Name, OID, and syntax Access Description
snLoopbackIntfConfigTable
brcdIp.1.2.13.1
None The loopback interface configuration table.
snLoopbackIntfConfigPortIndex
brcdIp.1.2.13.1.1.1
Syntax: Integer
Read-only Shows the port index for a loopback interface configuration
entry. There can be up to eight entries in this table.
Valid values: 1 - 8
snLoopbackIntfMode
brcdIp.1.2.13.1.1.2
Syntax: Integer
Read-write Indicates if loopback interface is enabled:
• disabled(0)
• enabled(1)
snLoopbackIntfRowStatus
brcdIp.1.2.13.1.1.3
Syntax: Integer
Read-write Controls the management of the table rows. The following
values can be written are:
• delete(3) – Deletes the row.
• create(4) – Creates a new row.
• modify(5) – Modifies an existing row.
If the row exists, then a SET with a value of create(4) returns a
"bad value" error. Deleted rows are removed from the table
immediately.
The following values can be returned on reads:
• noSuch(0) – No such row.
• invalid(1) – Row is inoperative.
• valid(2) – Row exists and is valid.